最近在使用tdc_gp22模塊做超聲波測距項目，但是在寫入0x70，0x05，并產生中斷后，讀取狀態(tài)寄存器的的值為0x0408,。按數據手冊里的描述，0x0408 & 0x0600 > 0 時即錯誤。

狀態(tài)寄存器

		//這里是我的寄存器配置
		uint8_t config_reg0[]={0x80,0xA3,0x0B,0x68,0x11};
		uint8_t config_reg1[]={0x81,0x21,0x44,0x59,0x22};
		uint8_t config_reg2[]={0x82,0xA0,0x23,0x00,0x33};
		uint8_t config_reg3[]={0x83,0xD8,0xA2,0x48,0x44};
		uint8_t config_reg3[]={0x83,0xD8,0x51,0x03,0x44};
		uint8_t config_reg4[]={0x84,0x20,0x00,0x4A,0x55};
		uint8_t config_reg5[]={0x85,0x40,0x00,0x00,0x66};
		uint8_t config_reg6[]={0x86,0xC0,0xC0,0x60,0x77};	
		

		tdc_Write(config_reg0,sizeof(config_reg0));HAL_Delay(10);
		tdc_Write(config_reg1,sizeof(config_reg1));HAL_Delay(10);
		tdc_Write(config_reg2,sizeof(config_reg2));HAL_Delay(10);
		tdc_Write(config_reg3,sizeof(config_reg3));HAL_Delay(10);				
		tdc_Write(config_reg4,sizeof(config_reg4));HAL_Delay(10);
		tdc_Write(config_reg5,sizeof(config_reg5));HAL_Delay(10);
		tdc_Write(config_reg6,sizeof(config_reg6));HAL_Delay(10);